Silly me. I can not find the measurements for the seat hinge mounts that I took before replacing the floorpan.

I would be most grateful for anyone with their stock seats already out who could grab the measurements for me Or point me to a thread with this info already in it!

Just let me know where they are referenced from in the car and I can figure it out.

Thanks!!!

Nate

I checked on two of the cars in the shop. Here's two measurements so you can double check.

4.5" from the back wall to the rear edge of the plate.
7.25" from the back wall to the center of the hinge pivot shaft.

Thanks Mark!!!!

I used the crossmember as reference.

I bolt the plates with the hinge to the slider. Put the height adjuster in one of the notches in the part that is bolted to the crossmember,square everything up and weld them in. Works for me.

Jerry