toon1
May 7 2011, 11:07 AM
1.7L ecxhaust system, coated w high temp powder coat,w collector gaskets, will need an 02 bung plug $60-----pending
Bursch 2L collector blasted and ready for coating $25------sold
Sail panel trim(decent) $5-----sold
Gauges,volt and O/T, $15 ea $25 for the pair( wire harnes will come w if sold as a pair)-------SOLD
center console wire harness $5-----SOLD
Targa top latches $5
front turn signal buckets $5ea.------BOTH SOLD
94mm cy. w ring set ( cyl. are ok would be good for boring to 96) and base shims( there are only hree base shims) $40-----SOLD
Engine sheet metal $20------SOLD
Pass door glass and misc. hardware $15
Wire harness (1.7 I think) free--------GONE
pedal board good cond. needs throttle stop $5------sold
blue coil $5------SOLD
Carb. gaskets, $3
sorry this is so cut up guy's I'm not very computer savy
All Items are plus shipping to the lower 48... will deliver within 20miles of Tracy ca.
PP accepted
toon1
May 7 2011, 11:17 AM
sorry guy's I got this all screwed up
toon1
May 7 2011, 11:23 AM
QUOTE(toon1 @ May 7 2011, 10:07 AM)
1.7L ecxhaust system, coated w high temp powder coat,w collector gaskets, will need an 02 bung plug $60
Bursch 2L collector blsted and read for coating $25
Sail panel trim(decent) $5
All Items are plus shipping to the lower 48... will deliver withing 20miles of Tracy ca.
PP accepted
JeffBowlsby
May 7 2011, 12:20 PM
I'd be interested in the scrap wire harnesses if you can get them to me in San Ramon. I'd pay shipping. LMK
914itis
May 7 2011, 12:32 PM
QUOTE(Jeff Bowlsby @ May 7 2011, 02:20 PM)
I'd be interested in the scrap wire harnesses if you can get them to me in San Ramon. I'd pay shipping. LMK
you beat me to it!
toon1
May 7 2011, 01:35 PM
QUOTE(Jeff Bowlsby @ May 7 2011, 11:20 AM)
I'd be interested in the scrap wire harnesses if you can get them to me in San Ramon. I'd pay shipping. LMK
OK, it's your's
matteyp
May 9 2011, 02:04 AM
I will take the pedal board. Pm sent