I am using the 12 volt wire that provides voltage to the coil when the key is on to enable 3 low amp draw circuits. Right now they are temporarily cobbled together. Ideally, I'd like to find a 1-3 shielded spade connector. I found 1-2 connectors as shown below. Does anyone know if 1-3 connectors are available?

Yes, I could just wire nut, electrical tape, butt-crimp and/or solder them together...

This is what I found at McMaster Carr...

http://www.mcmaster.com/#lug-terminals/=cqlept

Yea, I've got a single to dual splitter and one piggyback terminal as of now. I swear I've seen a 1-3 split or maybe a 2-2 in the past. Stupid details...