I need the following 1.8 LJet parts...

1. ECU
2. Air box w/ AFM
3. vacuum fuel pressure regulator
4. cold start valve (1.8 version)
5. AAR (1.8 version)
6. deceleration valve (1.8 version)
7. 1.8 TPS
8. Thermotime switch (two pin 1.8 version)
9. double relay
10. resistor pack
11. plastic charcoal canister

Mark,

Have you got part #s?

I'll check my stash if so. Most you can have for shipping if I can find the right match - Air Box for sure, the AFB I haven't repaired yet, but I'll look at it a bit prior to shipping if you want.

Thx,

Dave

I have some of these parts but I they were not on the shelf I thought they were so i will have to find them to verify condition. I should have a complete 1.8 system but I am only going to note the parts I recall seeing.

1. ECU - I have this but never knew if it worked or not
2. Air box w/ AFM - Have the air box but don't think either AFM is any good.
5. AAR (1.8 version) - Had this don't know if I still do
7. 1.8 TPS - I have this but it was off the TB
9. double relay - Think I have this
10. resistor pack - Have one that has been re-soldered
11. plastic charcoal canister - Think I have this

Are you coming up for the reunion on Saturday?
I'll look thru my stuff in the daylight and see what I can put my hands on.
Do you have a harness?

I also have a 2.0L EGR valve for your 2.0L Smog parts ad.

Jim

PM sent

What year is it for?

There are 6 and 7 pin AFM's.

I should have one of each.

Bruce

Hi, I've got a complete working 1.8 L FI system. every thing but the canister. I have the fuel rails with new bosch injectors. The AFM is new (rebuilt), new cold start, fuel regulator. Let me know. thanks.

Yepperz as Mr. Stone said.....74 and 75..had diffs....
75 decel valve
Throttle body...
TPS..was 3pin ..not two.....
diff on dizzy......
7 pin system for brain and AFC....
vac hose routing.....
need to run RPM limiter rotor....
send the 2 harneses off to Bowlsby
(shameless plug sorry..but wise)...
also the Cali 1.8 had more plumbing......
thatz a start......