he he he he...
Nickies....he he he he.....

balanced crank, flywheel, fan.......

Nice! Time to change your signature

old vs. new

side view

oops..

head,...

SWEET!!!!!!!!!

Sweet

The stuff's almost too pretty to put together.

Dave

Yea, the case is not yet ready...so I just get out the components and look.....

Am I sick???? I have done it 3 or 4 times....

So you will have it all put together and ready to go for the weekend right?

Looks very nice, I like the polished chambers too. Are the vavles oversized?

It sure turned out pretty......

The chambers aren't polished...just shaped.

It won't run this weekend.... Too much else to do...

1. change the fuel lines in the tunnel
2. Por-15 the lower firewall...under the back pad.
3. Finish the jacking donut on drivers side...
4. open up the case for the 103mm cylinders

I would like to drive it before the snow flies....

here is my rust hole....

bad picture, but comming along.....I suck at welding....

Lookin' good. Lifters will be in next tuesday and i'll try to get them out same day. Keep your fingers crossed everyone!

Charles Navarro
LN Engineering
http://www.LNengineering.com
Aircooled Precision Performance