Please PM me if you have any laying around. let me know what your looking for as far as cash. Thank you!

Edit: Looking for L-Jet or D-jet!

If you do not need working injectors what difference does it make if they are 2.0 type?

I automatically typed it since they will be mounted in a 2.0 engine. I was going to try machining them to receive CIS injectors instead of trying to fab a new bracket.

I could swear I saw someone do this in a thread on here somewhere?

before the shutdown!!!

I'll check tomorrow but I think I have a couple. I'll send you a pm B.S.
(Before Shutdown).

Thanks Drew. They are on the way. Bill

Your welcome Bill, Thank you Sir!

Anyone else before the shutdown?

I have 4 untested, grungy yellow tops. Yours for shipping, if still interested.
Pat

PM sent. I'll take them. Thanks Pat!

Did you get my PM? probably not after I read Andy's thread about turning the email / PM feature off.

My email Address is:

drew_a_montoya@YahooDotCom

Since the CIS injector is a press fit with rubber "O" rings (no bracket), I would be machining inserts for the manifolds rather than fooling with stock injectors.

Not intended to dis your project.

No dis taken. I'm going to be using the body of the stock injectors, machining a press fit for the CIS. That way we can use the stock bracket and mounting. No welding needed if it works?!

Hold up. The CIS reciever cups on a VW 1.8l rabbit motor are screwed in. Is there enough meat in the intake manifold to drill and tap them to accept the rabbit injector cups? They're already bossed for the o rings.

Brass version:


Plastic version:

http://www.germanautoparts.com/displayimag...657373016356405

another