bam914
Oct 15 2011, 01:09 PM
I made the mold and had 904svo lay the fiberglass. I was going to duct air from the fog light opening on the EP car to this. You will need to have short manifolds for this to fit. I am not 100% sure if it will clear the engine lid latch or the trunk torsion bars. When I mocked it up my car did not have them. $100.00obo This is what it cost to have it made.
Click to view attachmentClick to view attachmentHere is a picture of the mold in the car.
Click to view attachment
bam914
Aug 4 2012, 08:43 PM
bump
Any interest in this?
euro911
Feb 21 2013, 02:54 PM
Blake, does it clear the stock rain tray?
bam914
Feb 21 2013, 10:16 PM
No. It comes right up to the grill. I honestly don't remember what intake manifolds I used when I made it. I think they were the shortest ones I had. Since I built it for my race car that is gone I am not sure if it clears the trunk springs or the latch bracket. All that was cut out of my car. I will let it go for the shipping cost.