Is there a template, or measurement I could use to put timing marks on my fan itself?
I know about the one from pelican for the housing, but I would like one degree marks on the fan itself.
I am not certain I can accurately measure the diameter of the fan...hoping someone knows that number...I can do the math from there.
Rich
Full Version: Timing marks on fan
This one is made to mark the fan itself.
Why would the diameter be hard to measure?
Either you need a very large set of calipers or something else as neat.
There is a large protrusion on the back that gets in the way for a simple ruler or tape measure.
Rich
There is a large protrusion on the back that gets in the way for a simple ruler or tape measure.
Rich
The fan diameter I measured is 227mm. Circumference would be 713.234 mm. One degree would equal 1.9812 mm
QUOTE(r_towle @ May 27 2012, 06:57 PM) 
Either you need a very large set of calipers or something else as neat.
There is a large protrusion on the back that gets in the way for a simple ruler or tape measure.
Rich
Measure the circumference. A flexible tape or even a paper tape from IKEA works nice.
And you can also check in the shop manual. They have the exact measurement for the timing marks there. Page 3-3 2/3
Click to view attachment
This is a "lo-fi" version of our main content. To view the full version with more information, formatting and images, please click here.