Being a newbe is such a pain. Figured out I have the oddball temp sensor with the resistor on top.
Found it toward the back of the passenger side head near cycl 3. What a pain of a location. The wire is busted off. My question is, "how do you get this out?" and "when you get it out how do you get it back in?"
Full Version: '73 2.0 Head Temp Sensor
Got a photo of what you have?
13mm deep socket. Run the wire thru the socket, then insert an extension with one corner ground off for the wire to pass by.
QUOTE(vsg914 @ Jun 22 2012, 04:55 PM) 
13mm deep socket. Run the wire thru the socket, then insert an extension with one corner ground off for the wire to pass by.
Got it out - what a chore - where do I send Christmas cards to the designer of this? Thanks for the heads up.
QUOTE(pbob42 @ Jun 22 2012, 04:56 PM)
QUOTE(vsg914 @ Jun 22 2012, 04:55 PM)
13mm deep socket. Run the wire thru the socket, then insert an extension with one corner ground off for the wire to pass by.
Got it out - what a chore - where do I send Christmas cards to the designer of this? Thanks for the heads up.
Where can I get one of these?
QUOTE(pbob42 @ Jun 22 2012, 05:14 PM)
QUOTE(pbob42 @ Jun 22 2012, 04:56 PM)
QUOTE(vsg914 @ Jun 22 2012, 04:55 PM)
13mm deep socket. Run the wire thru the socket, then insert an extension with one corner ground off for the wire to pass by.
Got it out - what a chore - where do I send Christmas cards to the designer of this? Thanks for the heads up.
Where can I get one of these?
Anders says the 1.7 sensor or the 2.0 sensor from others years will work. Is this correct?
OK - figured it out - use the 1.7 L cht from '73 and throw in a 270 ohm balast resistor.
This is a "lo-fi" version of our main content. To view the full version with more information, formatting and images, please click here.