I did a quick look and saw AA has tabs for a Weltmeister bar...does that work or is there a more specific tab to use?
Full Version: putting factory sway bars on a non-bar car
Make sure you weld in the plate adapters, too. (also shown in the link that Eric provided)
QUOTE(rjames @ Jan 16 2013, 09:00 PM) 
Make sure you weld in the plate adapters, too. (also shown in the link that Eric provided)
All ready got everything else...I was going to swap out the A arms, but decided it would be a lot easier just to do the weld on adaptors.
Ordering them now.
Thanks guys!
QUOTE(euro911 @ Jan 16 2013, 09:44 PM)
Mark, who currently sells those??
Mark Bland (Engman) used to make them. Unfortunately, Mark passed away a few months ago.
I have access to a waterjet, if there is no one making these I'd be happy to pick this up.
Besides, I can use a set too.
Besides, I can use a set too.
QUOTE(euro911 @ Jan 19 2013, 09:05 PM)
Mark Bland (Engman) used to make them. Unfortunately, Mark passed away a few months ago.
OMG, I didn't know that...I bought some other conversion parts from him last spring.
RIP Eng
Mark, I'd take a set if you're going to load the program to cut some.
QUOTE(Mikey914 @ Jan 20 2013, 02:32 AM)
I have access to a waterjet, if there is no one making these I'd be happy to pick this up.
Besides, I can use a set too.
I'd be in for 2 sets.. keep us updated...
The next group buy ??
I posted a want ad back in December. I'd like a set as well, Mark
This is a "lo-fi" version of our main content. To view the full version with more information, formatting and images, please click here.