arcadeforever
Dec 3 2013, 09:39 AM
I was wondering if anyone has a metal template for the hell hole area and maybe other areas that they have repaired? That might be an interesting thing to archive on this site.
McMark
Dec 3 2013, 10:50 AM
PM maddog here on the site, I think he has a few precut pieces.
But what I do is use filing folders to make paper templates, transfer them to 20g steel and cut out with a cutoff wheel on an angle grinder.
boxsterfan
Dec 3 2013, 10:58 AM
QUOTE(arcadeforever @ Dec 3 2013, 07:39 AM)
I was wondering if anyone has a metal template for the hell hole area and maybe other areas that they have repaired? That might be an interesting thing to archive on this site.
I don't, but these guys do.
http://www.restoration-design.com/mm5/merc...tegory_Code=914
nathansnathan
Dec 3 2013, 11:51 AM
You can cut 18 gauge sheet metal with aviation snips, 20 gauge easy. You get a little distortion at the edge but it hammers flat easy enough.