Any thoughts in enlarging the drain back hole?
I also have a questions in the oil filler neck. I used PST 565 (loctite) for the o-ring seal. Its been leaking. Maybe not liberal enough with the goo?
Shane
HAPPY DAD DAY, EVERYONE!!!!
Full Version: Stock oil baffle
Hey Paddock people,
Any thoughts in enlarging the drain back hole?
I also have a questions in the oil filler neck. I used PST 565 (loctite) for the o-ring seal. Its been leaking. Maybe not liberal enough with the goo?
Shane
HAPPY DAD DAY, EVERYONE!!!!
Any thoughts in enlarging the drain back hole?
I also have a questions in the oil filler neck. I used PST 565 (loctite) for the o-ring seal. Its been leaking. Maybe not liberal enough with the goo?
Shane
HAPPY DAD DAY, EVERYONE!!!!
There are other versions of that piece with a larger hole. The ones with the PCV valve. You can gut the PCV valve to increase flow, or you could weld a section of pipe on in place of the PCV. But in a stock setup, that's not a drain back, it's just a path for air to flow (with some oil vapor).
QUOTE(McMark @ Jun 24 2014, 01:54 AM) 
There are other versions of that piece with a larger hole. The ones with the PCV valve. You can gut the PCV valve to increase flow, or you could weld a section of pipe on in place of the PCV. But in a stock setup, that's not a drain back, it's just a path for air to flow (with some oil vapor).
I just drilled straight through mine with a 3/4" drill bit.
This is a "lo-fi" version of our main content. To view the full version with more information, formatting and images, please click here.