This sheet metal looks to have been a later replacment as it is still in primer below the trunk floor, on the back side where the exhaust goes. The rear trunk floor was also braised to it in about 10 spots, rather than the correct spot welds. I cut it just outside the original seams. No signs of collision damage, a few minor dings, no rot but surface rust on the area that was bare primer). I am willing to ship at cost, or pick up in San Jose, CA. SOLD $100.

thanks,
Carl

Click to view attachment
Click to view attachment
Click to view attachment
Click to view attachment
Click to view attachment
Click to view attachment
Click to view attachment
Click to view attachment
Click to view attachment
Click to view attachment
Click to view attachment

SOLD!

Thanks Mark.