I know these will not be a really big seller as the 1.8 is the bastard step child, but I have a few guys that needed these so I decided to take them on.

If you need one or even think you may need one now's the time. The tooling is almost complete so these should be ready end of next week.

So who needs em?

I don't need one but have you considered the 1.7 gasket?
Very similar and a lot more of them out there.

I'm in; a must if you run L-Jet.....

I will take one. Thanks!

Put me down for 2, please.

I would take one.

Thanks!

I'll take one.. Bill

I think I want one but not sure what it is...

Interested.

I do have the 1.7. It's a hand molded part so not a pretty, but they aren't a big seller. So yes, I have them.
These I went to the aluminum tooling for a higher quality part.

Mark,

One set please .

David

I wanna be in for 2 please.Jaymann

Thanks guys,
An Australian dentist sent me some molds to work from, but we couldn't pull high enough quality parts from them, for production so we went to hard tooling.
I figured if he went through all the effort there were probably a few others that would appreciate the part.
Really pretty good work, but we couldn't use it.

I would like one please.

Sorry a little longer than 10 days. but the 1st one was pulled today and they look great. I'm also opening up another GB so if you want to combine you will be able to do that too.

Photo bomb!

These will be ready this next week with a few other items.
-mark

PM's sent to all
Thanks

+1 please

In for 3 mark.

K

+1 Please. Thanks Mark.