For sale:
Rear Back Pad
Passenger side particle board, on the back has been trashed in it's past. I'm not 100% certain if the vinyl on that side has been cut, or not? One of the metal clips is missing on that side.
The center piece is in above average condition, but has some crow's feet around where the light fits in at.
The driver's side vinyl is in above average condition, with one crow's foot around where the pull cable is for the engine lid grille. The particle board on that section towards the outside edge has been glued in it's past, and one of the metal clips was replaced with a fabricated one, which seemed to fullfill it's job.
If the particle board on the passenger side is not wanted, I could pull the staples, and send the vinyl, and the metal clip from that side, and pitch the particle board?
$70.00 shipped.
Click to view attachment
Click to view attachment
Click to view attachment
Click to view attachment
Click to view attachment
Click to view attachment
Click to view attachment
Click to view attachment
Click to view attachment
Click to view attachment
Click to view attachment
Click to view attachment