clean, no cracks at the screw post holes. $27 each shp included. 2 'dome' style and 1 sloped.

Do you know if one of these would be correct for a '70 -6?

If so I'm interested.

no idea about a 6 application. i think the one on the right is for an earlier car. one of the smart guys around here will know.

PM sent.

I also sent a PM.

I will take the "slope style" cover if it is still available. PM sent.

the 'sloped" one is sold.

k

2 Left are early pre-3-point seatbelt cars (70-72) & sloped right is late 73-76 with 3-pt. belts (slope accommodates upper belt mounting.

IIRC the early ones were the same for /4 & -6 914s, but a sixer can chime in if I'm wrong!

while looking for something else i came across this one. has a little knurled plastic piece in the hole, the area around the hole hasn't been dimpled and has a slightly raised lip. factory idea to keep water out of the relay board on a 6?

Thanks for posting the other one.