I need some clarification. I have temp. seats in my car, but I am going to install a nice set I have stashed in the attic.
The one on the right sets off vertical by a couple inches. I remember some discussion about this a couple years ago.
Is the difference in the seat or the rails?
My adjustment levers are on the correct side, so could I have assembled the seat rail incorrectly?
I want to make sure my good seats are installed correctly.
Thanks Mike
Full Version: Right/Left Seaats
QUOTE(xperu @ Jul 18 2015, 07:51 AM) 
I need some clarification. I have temp. seats in my car, but I am going to install a nice set I have stashed in the attic.
The one on the right sets off vertical by a couple inches. I remember some discussion about this a couple years ago.
Is the difference in the seat or the rails?
My adjustment levers are on the correct side, so could I have assembled the seat rail incorrectly?
I want to make sure my good seats are installed correctly.
Thanks Mike
I installed a drivers seat on the pass side without issue. I did swap the rails though and it was a race car. If there is a difference, it's subtle. Just inspect and try your best. Either you nail it or you don't.
There is a difference in the seats. The back of the headrests are angled to match the curve of the engine and rear trunk lids.
Installed correctly
http://germancarsforsaleblog.com/wp-conten...-914_6-Rear.jpg
Installed incorrectly
http://www.914world.com/bbs2/index.php?act...t&id=499518
Installed correctly
http://germancarsforsaleblog.com/wp-conten...-914_6-Rear.jpg
Installed incorrectly
http://www.914world.com/bbs2/index.php?act...t&id=499518
they have different part numbers and sit differently in the car. There is a cutout on the driver seat for the parking brake and even the cushions differ slightly. That being said, many times the driver seat is worn and sometimes the fiberglass is cracked since the left side gets heavily leaned on when you enter and exit the car. the passenger seat works fine if that's what you got.
QUOTE(mepstein @ Jul 18 2015, 10:13 AM)
they have different part numbers and sit differently in the car. There is a cutout on the driver seat for the parking brake and even the cushions differ slightly. That being said, many times the driver seat is worn and sometimes the fiberglass is cracked since the left side gets heavily leaned on when you enter and exit the car. the passenger seat works fine if that's what you got.
These are not the original seats in the car. The one on the drivers side fits correctly, the one on the passenger side tilts.
Like the incorrectly installed on previous post "Thanks by the way".
So I thought either the seat or the seat rail, or the bolt pattern I could tell which was the correct install. Thanks for your help. Mike
You may have 2 drivers seats?
[quote name='dlkawashima' date='Jul 18 2015, 12:20 PM' post='2211970']
An old thread about the differences ...
http://www.914world.com/bbs2/index.php?showtopic=149932
[/quote Perfect! I could not find this thread. Thanks to all of you. I never noticed the difference with the E-brake indent on the driver side seat. Again thanks Mike
An old thread about the differences ...
http://www.914world.com/bbs2/index.php?showtopic=149932
[/quote Perfect! I could not find this thread. Thanks to all of you. I never noticed the difference with the E-brake indent on the driver side seat. Again thanks Mike
This is a "lo-fi" version of our main content. To view the full version with more information, formatting and images, please click here.