I am getting ready to get the tub media blasted. I have some questions:

1) The bottom area by the back of the door opening where the rocker valance screws into the body doesn't look right. What should it look like?

2) the sticker on the driver side door opening, how do I clean the paint off it and protect it from media blasting?

3) the body sealer isn't correct. how and what do I use to make it look stock?

The sill to rear quarter on each side is normal.
It gets covered by the top flange of the rockers.
The door stickers are available as perfect repros WITH your VIN properly applied.
Look for "compliance sticker"
The body sealer has been removed or messed with.
It's tough to recreate the messy application and texture of the original material.