I need to know of a machine shop that can open up a set of heads for 94mm cylinders in the Fresno area.

Thanks in advance.

Engine Machine Service in WLA (310 671 4019) is as close as the big brown truck, and they know what they're doing, being long time aircooled specialists. The Cap'n

I can do them here.
I am just trying to save the fellow shipping cost.
And time.
He has 1.7 heads that were on a 2.0 block with the early 96mm Big Bore kit that accepted the 96mm cylinders without machning.

He didnt know that when he bought theP-C Kit , he found out this
morning when he tore down the engine.

I am sure there is a shop up there that can do this simple operation.