1. Those of you who lowered your car, how far off the ground are the centers of
the torsion bar caps?
2. What is the correct "rake" or ride height from front to rear?
3. Where is the best place to take measurements?
Full Version: Setting ride height, rake front to rear?
I switched tires from 205/60/15 to 195/55/15.
1. Those of you who lowered your car, how far off the ground are the centers of
the torsion bar caps?
2. What is the correct "rake" or ride height from front to rear?
3. Where is the best place to take measurements?
1. Those of you who lowered your car, how far off the ground are the centers of
the torsion bar caps?
2. What is the correct "rake" or ride height from front to rear?
3. Where is the best place to take measurements?
QUOTE(Geezer914 @ Mar 23 2016, 01:38 PM) 
I switched tires from 205/60/15 to 195/55/15.
1. Those of you who lowered your car, how far off the ground are the centers of
the torsion bar caps?
2. What is the correct "rake" or ride height from front to rear?
3. Where is the best place to take measurements?
1. Can't remember. I try to set it so the tie rods are parallel to the ground with the car loaded.
2. Irrelevant. Do a corner balance of the car instead.
3. See 1. and 2.
![popcorn[1].gif](http://www.914world.com/bbs2/style_emoticons/default/popcorn[1].gif)
Lower the back
then lower the front a little more.
then lower the front a little more.
This is a "lo-fi" version of our main content. To view the full version with more information, formatting and images, please click here.