Looking for a BTDT on the Q measurement ?
Distance between flange inner edge of rear panel and vertical part of rear floor panel through center of vehicle
Seems like there should be a specific point. High or low and the value will change.
Full Version: Reference points for the Q body measurement
Once you know the given value. Not real tough.
Doug's taillight panel install : Dead on
Three other cars checked : Dead on
Current project : Bowed out 3/8"
Which totally screws up the latch support alignment No in to out adjustment.
Click to view attachment
Doug's taillight panel install : Dead on
Three other cars checked : Dead on
Current project : Bowed out 3/8"
Which totally screws up the latch support alignment No in to out adjustment.
Click to view attachment
This is a "lo-fi" version of our main content. To view the full version with more information, formatting and images, please click here.