See latest post.

50ft box about $185-190 at the usual online places. Half is a little more than needed but it's cheaper than local by a bunch.

Shipping either to or from Las Vegas 89121.

Not in a hurry but do need to install it before April.
-----------

On the wish list:
Me - Vegas
ThePaintedMan - Florida
madmax914 - Oregon
BigFour1973 - Socal
BuddyV - Socal
mgp4591 - SLC

Ahah! That means you'll be at Rt 66.

bi-monthly

Sounds good to me Chris. I need to buy some for the EG33. I'm pretty sure 1 1/4 is what I need.

Chris, who are you buying it through? I'll be needing some her shortly.

https://www.amazon.com/Gates-28445-Heater-Hose/dp/B000CRHLF8

Madmax914- Id be up to go halves on one of these with you. 50ft roll 1 1/4

Is this for a SBC V8 application?

.... if so, I would be in for half an order. I have some old hose in my used kit..... probably best to start fresh.

I forgot to sub to my own thread

Rockauto currently $172.50 + $10 shipping. It usually comes out of Phoenix for me so no tax.

West coast obviously cheaper for reshipping.

I need to also get a 1.25" to 1.5" flex hose after I figure out which length fits better, so I figured I'd order it. Probably in a week or two.

Doesn't matter to me where the other half goes if the coastal guys want to wheel and deal with each other. As long as I don't have to hold on to it for too long.

i think the RH kit does 1" in and 1.25" out, about 10ft each way. Depends on you rad and fittings if 1.25" makes sense.

I'm up for splitting an order with someone. I'd volunteer to drive down to Vegas Chris, but you remember how the last trip went...

Got my box of hose.

Box size 28 x 28 x 8 & 15 lbs. Might be able to get it in a smaller box once I get my half pulled out, but it doesn't bend so good.

Fedex Ground to FL ~ $54
SLC Utah ~ $27

That's with my account. Honestly, more than I expected.

Half of $172.50 for 25ft plus shipping, or maybe 2x 13ft.

Can bring to Route66 or hold if someone is driving thru Vegas.

My 35mm/ 1 3/8" Toyota rad and Nissan engine outlets needed lube to get it on, so not quite a good fit like someone had led on

Chris, let me make some measurements to see if it will fit my radiator without killing it. I should be able to get to it tomorrow and let you know.

I'm interested in 20feet or so. montana

If the above falls through, I'll buy your other half.

PM sent...

Sold to Mike - mgp4591 whatever that means