Wanting to get my suddenly spare 2.0l off the floor and onto my engine stand. Having trouble finding studs/bolts of correct size to thread into the bottom 2 mounting holes (threaded into the cases)?

Anyone know this off the top of their head?

The threads are slightly munged up, so I will chase them with a tap if I can determine the size.

M10mm X 1.50

Thanks so much...

Did you remove these studs? Only asking as these lower 2 studs on mine are about 5_7mm too short. Was thinking about splicing and welding an extension onto them but if they unscrew that would be a bonus.

Yes, they can be removed.