I have this original valance that I will be making in the future.

I need to know if the "dent" pointed out needs to be there or taken out.

thanks,
Pete

Click to view attachment

Click to view attachment

ooops, wrong forum

Admin please can you move to the garage

My input :

Mine is straight across with no dent, but that's not to say it's correct.

Say goodbye to sky high prices on 6 valances.

Pete, you are a savior!

Put me down for the first one!!!!!!!

These will be at least 6-8 months. Please dont hold your breath

Pete

Pete, I can wait, no worries. Take your time.

Me too.

Any chance you'll offer these with no exhaust hole? For those of us with our own plans for exhaust systems?

I can for sure offer them without the holes.

Pete

Then the early 4 guys can get in on the action.

Put me on the list for one, if there is in fact a list. Thanks!

Hopefully the fronts aren't too far behind! The metal front valances command stupid prices for the rustiest, beat up, dented panels on the car!

Moved to the Garage, and

Pete, does yours have the 2 braces on back, from screw hole to bottom edge ??

It for sure does have the two braces on the back!

Pete

I hope you guys decide to make the shorter rear valances as well, in metal !!