Help - Search - Members - Calendar
Full Version: Sold - V8 Project
914World.com > The 914 Forums > Classified Forums > FS/WANTED: 914 Cars and Rollers
bulitt
Sold smile.gif



Bring your trailer, send a transport, send a pod container? Whatever...


W.NC Mountains near Asheville.
Where to start...This is a used vehicle. Non Running. No Brakes Working. Project Vehicle needing assembly and inspection by a qualified certified machanic.

First- at this time, I am not interested in splitting this car or selling individual parts.
Second- All nuts, bolts, all components need to be checked for torque, and proper installation. By a qualified individual.
Third- sold AS-IS. No warranty.
Fourth- Tub and motor were checked by NCDMV Theft Inspectors. All clean on that end. Title is clear but I believe it is titled as a custom/specialty due to the engine. In NC when you finish the vehicle the inspectors determine how to title it. So I checked the Title and it is titled as a 1970 Porsche 914. Stamped in top right corner "Inoperable Vehicle". So apparently it could be inspected and placed in service with a 914 motor and titled as a Porsche 914. But not sure, and all states are different.

1970 Tub. Good. Prior owner(s) did much work.
Patrick FG bolt on flares
Sheridan Rear deck spoiler (not attached at this time).

Click to view attachment

Click to view attachment

Click to view attachment

Click to view attachment

Click to view attachment

Click to view attachment

IPB Image

No clutch cable or throttle cable in car.
Fuel tank is really clean. Fresh paint on outside. New aluminum fuel line.

Click to view attachment

Interior- Only decent parts are - visors - 914 rubber reman new condition.
Seats recovered in black never sat in. These seats are Very Nice!
Steering wheel VGC
Lower dash in VGC

Wiring harness out of a 1973. Intact as far as I know.
Gauge cluster needs rebuild don't know if any gauges work cause I never drove it.
New style fuse block
New 914 rubber dash face material
Single key works the ignition, both doors and trunk.
Top in decent shape
No outside mirrors.
No windshield
Door glass -Needs felt, gaskets installed.
No parking brake handle/mechanism.
No seatbelts
No heater stuff at all. Fan has new gaskets etc.
Window regulators work well.
No carpet. Have center armrest-meh
New 914 rubber dash material
Have alot of bolts and little pieces.
Chrome windshield trim
side pillar trim
No other interior parts included.

Click to view attachment

Click to view attachment

Click to view attachment

Click to view attachment

Bumpers are dented. But IMHO can be pounded out.
Bumper tops are excellent fr and R.
Lights are all good. Motors work well-last I checked.
Radiator needs to be plumbed, shroud made, fans installed.
Yellow stripe coolant hoses included.
Fans included
Paint not so good. 2 different shades on car. Have paint code to match flares, spoiler.
Panels need work. Only major dent in trunk lid. Door dings. No obvious rust. But
AA Flared FG rockers- New- included.
no jack included
Windows need adjusting.

Click to view attachment

Click to view attachment

Click to view attachment

Click to view attachment

Click to view attachment

Click to view attachment

Click to view attachment

Click to view attachment

Click to view attachment

Click to view attachment

Click to view attachment

Click to view attachment
bulitt
Renegade V8 kit. With Performance clutch upgrade- zero miles. Have Renegade instructions.
Transmission rebuilt at Dr Evil clinic. Has flipped "H" gear installed in 5th.

The Engine is a 1968 327 SBC rebuilt .60 over. 30 minute break in, no additional hours. Per seller has 300hp cam. Edelbrock manifold, carb, elec choke. Electronic ignition, larger valves, roller rockers.
Deadenbear water pump and manifold. Single wire chrome alternator, headers. No mufflers yet.
High Torque Starter.
Wire looms
Plug heat boots. See pics below for current air cleaner.
Billet air cleaner in pics wouldn't fit so not included

Click to view attachment

Click to view attachment

Click to view attachment

Click to view attachment

Engine break-in

Click to view attachment

Click to view attachment

Click to view attachment

Intended look---

Click to view attachment

yerpants
Holy crap, that is one heck of a deal!

GLWTS
bulitt
Chrome windshield trim, gauges, new FG Rockers.
Gauges are off 1973 914

Click to view attachment

Click to view attachment

Click to view attachment

Click to view attachment
Jim Hassad
Looking for a project just like this. I have a machine shop/restoration garage. Would you load everything onto a transporter and ship to San Diego, CA for this price?
burton73
idea.gif

Bob B
bulitt
QUOTE(Jim Hassad @ Sep 10 2017, 10:24 PM) *

Looking for a project just like this. I have a machine shop/restoration garage. Would you load everything onto a transporter and ship to San Diego, CA for this price?


PM sent.
bulitt
Price Reduction!
rhodyguy
Very tempting. Very...struggling to resist the urge. One of those times you plan on asking forgiveness after the fact
matthepcat
Great deal bump. If only it were closer. Great chassis for any watercooled conversion to start with.

bulitt
QUOTE(rhodyguy @ Sep 13 2017, 02:12 PM) *

Very tempting. Very...struggling to resist the urge. One of those times you plan on asking forgiveness after the fact


Kevin glad to see your health is good enough you are contemplating a project!
smilie_pokal.gif





burton73
This 914 V8 project car is screaming deal at $5,000 The cost to move a non running car to SD should not be more than $2,000 so you are $3,000 to the better than the deal before. I have no skin in this game I am just a tenner lover and have build a V8 914 before

Bob B piratenanner.gif piratenanner.gif cheer.gif cheer.gif
Andyrew
Killer deal!!
t collins
PM sent
Stingbee
Too bad, I was going to give you..........
This is a "lo-fi" version of our main content. To view the full version with more information, formatting and images, please click here.
Invision Power Board © 2001-2024 Invision Power Services, Inc.