Hi
wife is busy today...going to spend the entire day and night trying to get a jump on getting my motor tuned up.
going to take a look at my clutch today, while the motor is out of my car...looking for the torque spec for reinstallation......(unless its guten tight)
i am also going to be changing my push rod tube seals....looking for the torque spec for reinstallation of the rockers.....(I know this one should be torqued)
thanks
Joe

Rockers are 10 lbs., not sure about the others.

rocker arm nuts are 10.1 ft-lbs; reference pg 5.1-1/2 of workshop manual

bolt for pressure plate is 23.5 ft-lb loosen and tighten crosswise reference pg 27.1-1/2 of workshop manual

thanks for the info! I appreciate it
Joe