Ok so I am installing the 914 MC. with the quick install kit. have the flexable lines attached, but i dont really see how they will fit onto the barbs coming off the top, the naked barbs are pretty much right up against the firewall.
what am I missing?
thanks
Ok got that done, made it work, but on the electrical. it comes with a 1 spade fitting, the original is 2 spade - so swap out the connector fitting?
Full Version: new 914 MC install; clearance issues
Did you get the copy of the instructions we did up? If not I can resend.
Mark
Just drop me your email on a PM.
Mark
Just drop me your email on a PM.
All the new ones nes come with one spade. You just tape up the unneeded wire.
QUOTE(Mikey914 @ Feb 3 2018, 04:25 PM) 
Did you get the copy of the instructions we did up? If not I can resend.
Mark
Just drop me your email on a PM.
already tried that 2 seperate times, one pm one email, I must have screwed something up, because I never got the instructions. no worries, i think i got it worked out
QUOTE(Calwaterbear @ Feb 3 2018, 06:43 PM)
QUOTE(Mikey914 @ Feb 3 2018, 04:25 PM)
Did you get the copy of the instructions we did up? If not I can resend.
Mark
Just drop me your email on a PM.
already tried that 2 seperate times, one pm one email, I must have screwed something up, because I never got the instructions. no worries, i think i got it worked out
Just drop me your email if you need them resent. I have not got a PM from you as of yet.
Thanks,
mark
QUOTE(Mikey914 @ Feb 3 2018, 06:25 PM)
Did you get the copy of the instructions we did up? If not I can resend.
Mark
Just drop me your email on a PM.
Hello,
Could you send me the install procedure?
What’s your email? I can look up and see if you need the ones for the easy or standard.
Post the directions at the end of the GB thread for the MC's. 
This is a "lo-fi" version of our main content. To view the full version with more information, formatting and images, please click here.