This is for my Subie-conversion project (Grey Matter).
Looking for rear 3 feet (or so) of the center tunnel, with weld flange and a few inches of the transverse support bars attached. The tunnel in Grey was hacked up pretty badly in doing the first V8 conversion.
Let me know what you’ve got.
Thanks,
Tom
Full Version: WTB: back half of center tunnel sheet metal
You need the top portion? Or bottom?
QUOTE(hockeymutt @ Mar 4 2018, 07:01 PM) 
You need the top portion? Or bottom?
The top portion. Isn’t the bottom the floor pan?
QUOTE(theer @ Mar 4 2018, 09:17 PM)
QUOTE(hockeymutt @ Mar 4 2018, 07:01 PM)
You need the top portion? Or bottom?
The top portion. Isn’t the bottom the floor pan?
Looking to undo this....
Click to view attachment
Sorry guys. I stayed quiet because the PO’s “repairs” on my parts car are so bad that most of the panels are useless. The tunnel actually looks worse in person. It sort of undulates down the floor pan.
QUOTE(Amenson @ Mar 4 2018, 09:10 PM)
QUOTE(theer @ Mar 4 2018, 09:17 PM)
QUOTE(hockeymutt @ Mar 4 2018, 07:01 PM)
You need the top portion? Or bottom?
The top portion. Isn’t the bottom the floor pan?
Looking to undo this....
Click to view attachment
I've got one I'll chop out, pics are ugly but the flanges look good , my concern is the length at the rear 100.Click to view attachment
QUOTE(Amenson @ Mar 4 2018, 09:10 PM)
QUOTE(theer @ Mar 4 2018, 09:17 PM)
QUOTE(hockeymutt @ Mar 4 2018, 07:01 PM)
You need the top portion? Or bottom?
The top portion. Isn’t the bottom the floor pan?
Looking to undo this....
Click to view attachment
Better pic off a 76 Click to view attachment
If I understood the post correctly, you need to top section, which I have.
Still looking?
Found! Thanks, all.
This is a "lo-fi" version of our main content. To view the full version with more information, formatting and images, please click here.