When running the control cables through the tunnel (speedo, accelerator and clutch) is there any rhyme or reason on how to do it?
Do they just lay in the bottom of the tunnel or are some or all of them held with some of the tabs that are located inside the tunnel?
Full Version: Tunnel cable routing question for 914 brain trust
I think this link will help with most of your questions.
https://www.pelicanparts.com/techarticles/9...nter_tunnel.htm
https://www.pelicanparts.com/techarticles/9...nter_tunnel.htm
Thx. That was helpful. Wasn't aware that some of the cables have dedicated tubes that they run through. Seems like it's just the speedo cable that might be flopping around and could benefit from being held by the tabs available inside the tunnel.
The speedo cable runs along with the wire harness, so most of the way it is actually on top of the tunnel.
Jim
Jim
QUOTE(jcd914 @ Jul 20 2018, 10:51 PM) 
The speedo cable runs along with the wire harness, so most of the way it is actually on top of the tunnel.
Jim
That's useful, thanks!
QUOTE(cn2800 @ Jul 20 2018, 09:41 AM)
I think this link will help with most of your questions.
https://www.pelicanparts.com/techarticles/9...nter_tunnel.htm
CN2800, Thanks for posting that link. Very helpful information.
This is a "lo-fi" version of our main content. To view the full version with more information, formatting and images, please click here.