I have a late model heater blower motor that has both heater tubes exiting from one location. As compared to earlier heater blowers that was mounted to a frame that mounted onto the engine block and had two exits for the heater tubes the later model was tucked in under and in front of the relay board. How was the blower mounted? Anybody have any pictures. The pet katalog only shows the earlier model.

Thanks,
Buck

This is the late model fan, with the late late siamese splitter - typical set-ups only have a single hose to the drivers side. Bracket welded to chassis, rubber pad, strap around motor body.

very nice engine compartment!