Good morning, hope everybody’s had a good week so far.

Hoping to get some coaching/info about attaching the rear valance that sits under the rear bumper. Looking at PET it appears that it’s mainly held in place by self tapping screws and two 5 mm bolts? PET reference is a spacer but I’m not sure how thick that is - anyone know offhand?

Thanks!

I just installed one last week and used this - worked perfectly - http://www.autoatlanta.com/Porsche-914-Rea...B914503009.html

The 4 screws across the back use a small washer then the (2) on each side use the Nut/bolt and rubber spacer between the valance and fender

Spacer is the same one used on the front and rear of the rocker panel.

#14 x 3/4" worked well for me
Click to view attachment

Thanks gentlemen, appreciate the responses.