bkrantz
Nov 28 2019, 03:59 PM
I am trying to figure out how to reassemble the seam where the rear trunk panel meets the inner and outer rear fender metal. What is the stock "layering"? In other words, what panel in inside, outside, or sandwiched in the middle?
What I have is a bit of a mess, from a pervious crappy repair (with a replacement rear panel brazed on) plus some collision damage and some rust. And I would like to reuse the rear panel I cut out, after I straighten a bit in the middle.
gms
Nov 28 2019, 08:44 PM
inside to outside
- inner wheel house
- rear panel
- quarter panel
cary
Nov 28 2019, 09:15 PM
What Glenn said. You can see a piece of the tail light panel still in between the inner wheel house and qtr. panel.
bkrantz
Nov 29 2019, 10:52 AM
Thanks, everyone. That's what I thought but nice to get expert info.
cary
Nov 29 2019, 11:01 AM
Dig in here. I did a complete tail light panel swap on Doug's car.
http://www.914world.com/bbs2/index.php?act...=2&t=249327