SOLD
This is a set of the later, larger diameter pushrod tubes that were cleaned and replated. New Viton o rings were installed. Some small dents.
Will fit all Type IV except early 1.7L heads with smaller holes.
$80 for the set shipped USPS Priority mail in the U.S.
Paypal to bdstone914@aol.com
Bruce
QUOTE(bdstone914 @ Nov 30 2019, 08:19 AM) 
This is a set of the later, larger diameter pushrod tubes that were cleaned and replated. New Viton o rings were installed. Some small dents.
Will fit all Type IV except early 1.7L heads with smaller holes.
$80 for the set shipped USPS Priority mail in the U.S.
Paypal to bdstone914@aol.com
Bruce
If these will work with a 1974 2.0, I’ll take them.
@26s219
Paypal to bdstone914@aol.com
If these will work with a 1974 2.0, I’ll take them.
[/quote]
They do work with a 1974 2.0.
Bruce
Paypal to bdstone914@aol.com
If these will work with a 1974 2.0, I’ll take them.
[/quote]
They do work with a 1974 2.0.
Bruce
Are these thicker and stronger than the newly produced tubes?
I bought a "new" set and went back to my originals cause the new one were so easily crushed.
I bought a "new" set and went back to my originals cause the new one were so easily crushed.
QUOTE(Highland @ Nov 30 2019, 09:39 PM)
Are these thicker and stronger than the newly produced tubes?
I bought a "new" set and went back to my originals cause the new one were so easily crushed.
What brand new ones did you buy ? Dansk ?
They are quite sturdy. I have knocked out the dents by forcing them onto a round manderal and they are not easily damaged.
This is a "lo-fi" version of our main content. To view the full version with more information, formatting and images, please click here.