These headers came on my car from the PO.

They sound awesome - the only thing is - they sit a little low under the car. You can see in the close up that they're pretty worn down in one spot from scraping the ground.

My car has particularly low profile tires, so it did scrape a lot.

That said - it hasn't worn through yet - there's no hole in the pipes.

The magnaflow muffler I just got last summer so it's only about 7 or 8 months old. (that weird little bar on the muffler is a bracket the muffler shop made)

I'll sell both for $150 obo - or make me an offer on either individual thing.

I'm going back to heat for these frigid so cal nights.

I'm located in so cal (corona) would probably be expensive to ship.

Mike

Click to view attachment

Click to view attachment

Click to view attachment

Do you know how hard it would it be to fit these on a 2.0?

Actually I don't. But what's not pictured here are the little connector pieces. I actually have 4 connector pieces that go up on to the block. Then they stick down an inch or so below and you connect the headers to those. It makes it much easier to take on and off than regular heat exchangers. That said - I don't know if the spacing is the same from a 1.8 to a 2.0 - but surely someone knows and will chime in.

@coronamike @mendivil26
I believed it fit both 1.8/1.7 and 2.0

similar to european headers


Click to view attachment

Click to view attachment

Click to view attachment

Click to view attachment

Click to view attachment

What is the diameter of the primaries (the long tubes that bolt to the stub tubes)?

Measured around the outside of the tube they're 13 cm around.

Bump for a good seller

OK, PM Sent

Please buy this before my will power subside.
I need to get car running and get a better engine before I am ready for this.