Yellow zinc plated parts. All the parts are original, not reproductions. Small parts are $5 to ship, medium $7, large $10. Can combine. Email - mark@markepstein.net to purchase. Will take used parts as partial trade.

1. E-brake cable w/spreader bar & spring tab - $50 sold
2. Strut mounting plates - $40 set of 4 - sold
3. Engine lid latch & plate - $45 -one sold
4. Front lid lower latch - $40 - one sold
5. Front lid upper latch - $35 - one sold
6. Door latches - $85pr
7. Strut wedge pins - $20pr
8. Spare tire hold down plate - $20
9. Rear axle nuts - $30pr
10. Door hinge - $80pr - sold but found a second pair for sale.
11. Transmission washers - $30pr
12. Transmission washers w/ notch - $30pr
13. 911 fan pulley - $20
14. A-arm cover - $35pr - sold
15. Rectangular transmission mounting plate - $35/pr

Free bump for a good engine from a great seller, wait... what are these, not an engine?

;-)

PM sent for pair of door hinges

PM sent for e-brake cable

Mark,

if the E-brake cable parts are not sold I am interested,
would like to get if still available the A-arm covers, engine lid latch & plate, and the front trunk lid upper and lower latches.

- also I already have the front strut plates and washers from Bruce Stone but I didn't get the nuts, so if you have the strut nuts that go over the washer I'd like to source those.

Phil

Phil -
Mark,

if the E-brake cable parts are not sold I am interested, Sold, sorry
would like to get if still available the A-arm covers, engine lid latch & plate, and the front trunk lid upper and lower latches. All available - I'll pm you. Thanks

- also I already have the front strut plates and washers from Bruce Stone but I didn't get the nuts, so if you have the strut nuts that go over the washer I'd like to source those. - I don't have the nuts. They are usually included with new struts but I'm sure they are available at bellmetric, etc.

Phil

Also have these. The drop links are 911 length, not 914.

Strut top support mounts - $125/pr
Sway bar clamps - $125/pr - sold
Sway bar drop links - $75/pr

[size=1]

E-mail sent for spare tire hold down plate.

Mark,

I'll take a 911 fan pulley if it will fit a 1973.5 2.4L.

I'll take the tire hold down. Do you also have the screw?

The spare hold down plate is already sold to Jim.

Mark, do you have a 2nd 911 pulley halve ?

Let me check