Sunday 3/1/20
Sent the picture earlier however I don't see it. I've tried again to
attach the photo. Please let me know if you get it.
[quote name='xsurfer' date='Feb 29 2020, 07:17 PM' post='2790379']
Bruce,
Thanks for the phone call. I don't have your phone number.
I need the right side sheet metal 8 inches back. I will attempt
a photo of the area tomorrow.
Thanks
Gene
[quote name='xsurfer' date='Feb 29 2020, 11:33 AM' post='2790289']
[quote name='bdstone914' date='Feb 29 2020, 10:01 AM' post='2790270']
@xsurfer date='Feb 29 2020, 11:37 AM' post='2790265']
I need a piece of sheet metal cut from the inside right fender.
My car is a six however I think they are all the same. If you have
a car you are parting please let me know.
Thanks
Gene
[/quote]
Can you post a picture of the area need ? Front or rear ?
I have a parts car that is getting cut.
Bruce
[/quote]
Bruce,
That's terrific! I know you from years ago at the Riverside
Flesh eating swap meet.
You might know exactly what section I need. I have a factory six
that was damaged at the fuel pump mounting area of the inside right
inside fender. I need to cut a section out of the inside fender. I'll work on
getting a picture and measurements today.
Are you still in the Riverside area?
Thanks
Gene Selger
gene@eselger.com
8189575791
[/quote]
[/quote]