I a looking at supplying several different hardware sets. Need input on ones that are most needed.
for starters I am looking at:
1. license plate kit that would have the square nylon nuts, screws to attach the plate bracket to the bumper and screws for the plate to bracket.
2. Rear targa latch kit.
3. Front targa latch kit.
4. Front sway bar hardware kit.


Suggestions, comments?

Bruce - front sway bar kit for sure buddy. Put me down for one..... thanks Paul

I could use 2 sets of front & rear targa latch kits. Thanks.

One set each Front and Rear targa latch sets.

front sway bar kit !

@SO.O.C914er
date='Sep 18 2020, 09:56 PM' post='2852427']
Bruce - front sway bar kit for sure buddy. Put me down for one..... thanks Paul
[/quote]

I ordered up parts today for front sway bar. Should have them by the end of the week.

@DMAYHALL

@wes
date='Sep 18 2020, 10:46 PM' post='2852430']
One set each Front and Rear targa latch sets.
[/quote]

Parts are on order.

[quote name='bdstone914' date='Sep 21 2020, 11:43 AM' post='2853117']
@wes
date='Sep 18 2020, 10:46 PM' post='2852430']
One set each Front and Rear targa latch sets.
[/quote]

Parts are on order.
[/quote]

Thanks let me know when you need $$

Thanks Bruce.

wes
date='Sep 21 2020, 02:32 PM' post='2853164']
[quote name='bdstone914' date='Sep 21 2020, 11:43 AM' post='2853117']
@wes
date='Sep 18 2020, 10:46 PM' post='2852430']
One set each Front and Rear targa latch sets.
[/quote]

Parts are on order.
[/quote]

Thanks let me know when you need $$
[/quote]

I am adding the hardware that attaches the rubber block and bracket.
Next is the screws for the rear top seal trim. Bunch of litt ln e 3.5m screws. I found that early tops had stainless screws and layer had zinc played screws that rust.