Do all of the throw out bearings have the two guides? #9 in the picture. When I took mine apart these were not there.
Click to view attachment
Click to view attachment
Click to view attachment
Full Version: Transmission
There should be 2 of them.
you need these..
they often get reused, and then fall apart with age.
but you need them.
they often get reused, and then fall apart with age.
but you need them.
Get new ones every time you do a clutch.
Clay
Clay
Yay! More parts to buy. Thank you guys for chiming in
The retaining clip for the pivot is spent too. Replace the small ballcup bushing while you're in there.
QUOTE(rhodyguy @ Jan 5 2021, 12:18 PM) 
The retaining clip for the pivot is spent too. Replace the small ballcup bushing while you're in there.
The retaining clip seems to be ok but I have replaced the ball cup. Thank you!
Cheers,
John
Click to view attachment
Click to view attachment
QUOTE(Morph914 @ Jan 5 2021, 09:51 AM)
QUOTE(rhodyguy @ Jan 5 2021, 12:18 PM)
The retaining clip for the pivot is spent too. Replace the small ballcup bushing while you're in there.
The retaining clip seems to be ok but I have replaced the ball cup. Thank you!
Cheers,
John
Click to view attachment
Click to view attachment
Hello,
I'm going through the same process. Any other items need to be replaced before mating to the engine?- Replacing items 5, 8 and 9.
Is item #1 inside the transmission?
Thanks, Todd
While your in there ~
if you are cutting your flywheel vs new, consider you may need to shim the pivot ball out.
if you are cutting your flywheel vs new, consider you may need to shim the pivot ball out.
This is a "lo-fi" version of our main content. To view the full version with more information, formatting and images, please click here.