I'm missing the linkage shown in the picture.
Can one buy this part or must the whole flapper part be purchased?
Is there a common work around for those missing this part?
What does the stock set-up look like? Does the cable end just get held in with friction against the "spring clip"?
Thanks.
Click to view attachment
Full Version: Heater Flapper to Cable Connection
yes
Are you saying 914Rubber carries this part? @Mikey914
QUOTE(Highland @ Mar 3 2021, 09:42 AM) 
I'm missing the linkage shown in the picture.
Can one buy this part or must the whole flapper part be purchased?
Is there a common work around for those missing this part?
What does the stock set-up look like? Does the cable end just get held in with friction against the "spring clip"?
Thanks.
Click to view attachment
You need the part circled in addition to the barrel nut. The cable end inserts into the barrel nut and the 4mm bolt clamps it in place.
QUOTE(Highland @ Mar 3 2021, 08:20 AM)
Yes and at $1.49 each !
https://914rubber.com/barrel-nut-assembly-1
We even have the heater cables too, all 3 versions
How about the part circled in the OP? Is that available for purchase anywhere?
QUOTE(Highland @ Mar 3 2021, 08:23 PM)
How about the part circled in the OP? Is that available for purchase anywhere?
I have a spare. PM your address and I'll send it to you.
QUOTE(Highland @ Mar 3 2021, 07:23 PM)
How about the part circled in the OP? Is that available for purchase anywhere?
I could make them, but think it wouldn't be worthwhile in that there are quite a few unserviceable units they could be salvaged from.
Check around the VW websites, I have seen them out there for less than $5 each.
This is a "lo-fi" version of our main content. To view the full version with more information, formatting and images, please click here.