I was pulling the dogs off 1st gear and noticed this
Click to view attachment
There are chips broken off the gear cogs where they interface with the dog
Click to view attachment
The area that the two attach is seen below before separating
Click to view attachment
I am using the P225 to separate the dogs.
My questions
Is this normal? Am I doing something wrong? Is this a sign of an issue with the gears? Can I use this gear again?
Thanks in advance.
Mike
Full Version: Tranny gear issue
Actually if they are original dog teeth that looks normal.
Original dog teeth were staked in place along the edge of the splines.
Loctite does the job the original staking did.
I don't believe Porsche considered the dog teeth replaceable originally.
Jim
Original dog teeth were staked in place along the edge of the splines.
Loctite does the job the original staking did.
I don't believe Porsche considered the dog teeth replaceable originally.
Jim
QUOTE(jcd914 @ Apr 15 2021, 09:15 PM) 
Actually if they are original dog teeth that looks normal.
Original dog teeth were staked in place along the edge of the splines.
Loctite does the job the original staking did.
I don't believe Porsche considered the dog teeth replaceable originally.
Jim
Thanks Jim,
That explains the lack of this repair procedure in the factory manual.
I assume red loctite?
This is a "lo-fi" version of our main content. To view the full version with more information, formatting and images, please click here.