OK,

I took pictures prior to taking the system apart, but did not get the angle necessary for the drop link to figure out if the bent part goes UP or does it go down?

Well, I played with it for a while thinking I could think like a German...........didn't work.

Here are some pictures,................embarrassing....

The Bendy part is at the top of this picture

Click to view attachment


This is the straight part


Click to view attachment



Close up of the bendy part


Click to view attachment

Pretty sure the bendy-end goes on the a-arm, oriented so the the bend makes the top end link “lean” toward the mounting hole on the sway bar bracket. In any case, It should only fit one way.. the bendy-end on top will push the bottom end of the link left or right (flipped one way or the other), while the bendy-end on the bottom pushes the top end forward or back.

[quote name='ctc911ctc' date='May 28 2022, 05:07 PM' post='3004762']
OK,

I took pictures prior to taking the system apart, but did not get the angle necessary for the drop link to figure out if the bent part goes UP or does it go down?

Well, I played with it for a while thinking I could think like a German...........didn't work.

Here are some pictures,................embarrassing....

The Bendy part is at the top of this picture

Click to view attachment


This is the straight part
The straight end goes up. The bottom angles toward the center of the car.
[color=#FFFF00]Close up of the bendy part

So,

I have two answers, they are confusing me - my fault........

If I understand this ,

The bendy part is on the BOTTOM attached to the A-ARM

The STRAIGHT part is on TOP

I just installed it that way and it does not seem correct. I have the bendy leaning toward the MIDDLE of the car

Perhaps the car is bent?????? I will check that next!

Yes the angled part is at the bottom.

Rotate it 1\2 turn so the angle aligns with the tab on the A arm