Hi guys.
I’m recreating the bottom flanges of a center tunnel.
Don’t have a complete 914 near me right now to measure.
I am looking for the flange (or floor) to top of the tunnel in 4 spots, for verification.
Assuming around 2.25 for the rear, but having trouble with the front rise.
Measurement 1: near seat belt
Measurement 2: rear floor front (by horizontal support) near taper.
Measurement 3: middle of shifter.
Measurement 4: tunnel cancellation at front. (Near throttle cable)
I can add pictures if this isn’t clear. Thanks!!