New toy´s arrived today.
I will work on the valve train tomorow using the 911 swivel feet.
I know i must deck the rocker facing (o,o6" or 1,5 mm).

Anything else i should know?

not sure if i have to shim the rocker assembly too?
I think i am testing without shiming and wath the geometry should be the right way.

after you deck the rocker face, countersink the threadbore so there is plenty of room for the swivel.
find a tap to clean out the threads too.

what did you end up paying for those? OE porsche pieces correct?

I sell the Genuine 911 adjusters for 9.25- previously I had them at 8.00 but the prices went up because now I have to source the real ones from the fatherland.

Doing the install with these will also be complicated by the necessity of correcting your rocker geometry more than likely..

I'm fast tracking the "Jake's Notes" that covers geometry because so many people are goofing it up due to bad information- others just don't do it and their geometry kills the valve guides and power as well

dont look at me.