Full Version: heat flap saddle bearings
Redoing all of my cableing in the 2.0. Throttle, heater, clutch. As I'm installing a new thermostat I was wondering if it is possible to sneak new bearings "under" the tins without full removal.
Yes.
IIRC you'll need to loosen a few fasteners on the tin, but it's been done before.
Or you could always pull the engine and tranny
.
IIRC you'll need to loosen a few fasteners on the tin, but it's been done before.
Or you could always pull the engine and tranny
.
Got them and even the metal U clip
https://914rubber.com/cooling-flap-control-bearing-shell
https://914rubber.com/air-cooling-control-c...he-914-and-912e
https://914rubber.com/cooling-flap-control-bearing-shell
https://914rubber.com/air-cooling-control-c...he-914-and-912e
914 Rubber to the rescue!!!
This is a "lo-fi" version of our main content. To view the full version with more information, formatting and images, please click here.