Finally getting around to installing the beautiful SSI heat exchangers/extra parts I picked up from Euro911, and I’m there are 2 pieces to the puzzle missing (which I knew were not included when I bought the heat exchangers).

I’m looking for the mirror image of this under engine sheet metal (I think it’s the passenger side one I need) and another bracket that goes to the fan. See pictures for further information.

Click to view attachment

Click to view attachment

auto atlanta sells them, both versions, and for each side.

@NotLance

There are two sizes of the rectangular brackets.
The lenght is different. I have them. Figure out if is is the left or right side you need.

Thanks! Found the sheet metal on their site! Open to used ones as well - I can weld and shape if needed, but if no one has any that need a little love I know where to fall back to!

Looks like I need the passenger (shorter) one. Shoot me a DM

Lots available used. Sounds like you found what you need. If not PM me.
BTW nice looking build. Really like the stainless allen screws on the exhaust.

PS got the high temp silicone ones on the webiste if you need them. Best part is they are reusable.

PM Sent

Did a quick drive by of the parts barn. Found the one you don't need. Going to have to dig further upon my return. Thought I Had together.
Not back til late Thursday, so if anyone else has one handy?
If not I'll locate on my return.

SS Allens rule

Mark, Lance purchased the SS HEs & some of the ducting I had done up for my wife's car 'HOWARD'.

I still have 3 full sets of your SS Allen hardware kits that I'll be using on my 912 motors' tins - they look so much nicer than the CAD cheeseheads

Should have given credit where credit is due! Thankful to have been able to acquire such beautiful work.

Got a chance to take a closer look. There are both here. What I can’t see clearly is the one you have. Prettier sure the smaller on the left is the drivers piece. It has more of a taper just past the nut.
Please confirm which you need. $20 + actual shipping. Should be less than 5 bucks USPS with tracking.

Mark

I’ve got the big one, so I’ll take the little one with the taper. PM me your PayPal.

Picture to make sure I’m not crazy.

Click to view attachment

Anymore available? I need both.

don't forget, these need (cork) gaskets in the channels for sealing.

Hi guys hey where did you get those stainless steel allen screws for the pipes thank you , Joe

Took the old flat head to ACE and checked the threads on a thread gauge, then got the same pitch in a stainless allen head.

SS are so cool looking,

Just beware,

When you dropped one. anywhere you can't reach with your finger,
The Nifty Magnetic tool is of no help.


Unless you have a lil pick-up tool,
You're golden.

In fact, same tool used to put those SS bolts in,
(Some customers/clients has em on their motor, I don't )

IIRC, 914Rubber sells orange silicon gaskets for them

I picked up a set for the project, they seem high quality.

Link, please?

I searched the site for "orange" and "gaskets" and didn't see anything.

https://914rubber.com/heater-blower-plate-gasket-kit-1

Comes with the Stainless allens so even less incentive to use the flatheads