I have a running pair of Weber IDAs that I recently rebuilt. Shafts feel solid. I do have all the lock nuts for the top plate, just not fully on while I was adjusting the float height. Also, one of the bypass adjusters has a chunk missing. It does not leak air around it. You can see it in 3rd pic from the bottom, farthest left air bypass adjuster.
I rebuilt them to the following jetting:
Vents - 32
Main - 135
Air - 180
Idle - 55
Emul - F26
To run on a 2.7 CIS motor. I also have vents-30 & 34, main-130, air-170, F3, to swap prior to purchase based on buyers requirements.
Linkage, air horns, rain hats/filters included for full asking price. PMO manifolds extra ($450) 40/32mm
$2800 + ship
Running vid can be seen here:
https://youtu.be/oAuSeMdaoLs
