mikelsr
Oct 9 2005, 10:14 AM
Yesterday I was trying to raise the steering box up 1/2" with a bump steer kit. I must have cross-threaded one of the bolts because I can't get it in. I didn't apply much pressure to the bolt but I don't want to do any more damage so I want to tap it out. I think the bolt is a 10x22 (ok the new one is longer) and the threads are 1.50 but I want to make sure before I start working on it again. Does anyone know for sure what the size is?
TIA,
Mike
SirAndy
Oct 9 2005, 02:41 PM
QUOTE (mikelsr @ Oct 9 2005, 09:14 AM) |
Does anyone know for sure what the size is? |
i don't but i'm going to this for 'ya ...
Andy
Cap'n Krusty
Oct 9 2005, 06:45 PM
They would be 10x1.50. There are no 10x1.25s on a 914, and only rarely is 10x1.0 found (CHT sensor threads). The Cap'n
mikelsr
Oct 9 2005, 06:48 PM
Thanks for the reply. Now I just have to get under it again.
M
r_towle
Oct 9 2005, 07:12 PM
how thick is the "washer" that comes with the kit??
Rich
mikelsr
Oct 9 2005, 07:44 PM
about 1/2".
mikelsr
Oct 10 2005, 08:15 PM
10x1.50 tap did it. Front end is back together.
Cap'n, thanks for the info.
This is a "lo-fi" version of our main content. To view the full version with more information, formatting and images, please
click here.