Please see http://engmanparts.com for details

Included are two circular plates and two oblong plates and two bolt on plates and mounting hardware. No drilling is required - these bolt right in.

Here is a review of the product.

PM or email me.

Revised...

M

What about the holes in the tin for the J-tubes in the engine compartment?

dont have one for those - but - they can be made. How many do you want?

M

How much for the block off plate in/on the engine tin ( one for each side)?

Please see both questions on post #9 in this thread regarding the block off plates:

http://www.914world.com/bbs2/index.php?act...=0#entry1345383

Thanks a bunch!

Figured it out! It was an M6 x 1.00 screw! Problem solved.