any one make just "stock" length?

how long are 2.0L stock alum push rods?
I don't want to cut them

Ask Jake.

QUOTE (URY914 @ Jan 27 2006, 07:13 PM)

Ask Jake.

If you really want to know....

every motor is different. have youre heads been decked? are you running head gaskets etc?

all these influence rocker geometry.....

do it right. do it once.

You can buy cut to length CroMoly pushrods and cut them to the stock length. If you're making pushrods you might as well make custom length ones. But stock will work just fine. Buy the cut to length rods, pull out a stock one, measure, cut, install.

Ok
2 questions then

how long are stock so I can order adjustable one and do it right?

How do you cut them accurately? just a tubing cutter or do you use a lathe?

QUOTE (qa1142 @ Jan 29 2006, 03:35 PM)

Ok 2 questions then how long are stock so I can order adjustable one and do it right? How do you cut them accurately? just a tubing cutter or do you use a lathe?

I used a lathe, but I am sure that I was being anal.

-Britain

QUOTE (Britain Smith @ Jan 29 2006, 03:45 PM)

QUOTE (qa1142 @ Jan 29 2006, 03:35 PM) Ok 2 questions then how long are stock so I can order adjustable one and do it right? How do you cut them accurately? just a tubing cutter or do you use a lathe? I used a lathe, but I am sure that I was being anal. -Britain

i usead cutoff wheel, cut them long, and then filed them to the marks i made.

AA