Took alot of coaxing but I gottr done. hole saw top of piston ,then torch top of rod off,ugly.
Sancast :wub:case ,crank,cams,fan,flywheel, etc. all good.
Note; this for fun I knew what I was buying.

It'll buff out...

Use that pic as an avatar......it's certainly offensive.

I had a 2.4 that was exactly like that. MFI was good though

Sandcast on a car with vented rear rotors?

That's one of those 'hunts while idleing' engines isn't *it?

Hey, it looks a good as the car it was in. No, it wasn't a "storm surge special" from the SE.

No slipping in a set of rings on that little guy.

Now that is how you take apart a motor!!! witha torch!!! WooHoo, I bet those pistons can't be used now....

Naw....bead blast them....they'll look like NOS.

You may have to do a bit of welding on the rods though.

Looks like alot of parts MotorMeister could use.....

picture on right look like chili cookoff

mongo like chili


mongo